Products
Solutions
|
|
You are here: Knowledge Base > User Guides & Manuals
|
TS1201 operating instructions for use with a pressure pot Last Updated: 11/01/2012 |
|
OPERATING INSTRUCTIONS WITH PRESSURE RESERVOIR 1. Connect the fluid tubing from the material reservoir to the female fitting on the pen. 2. Hold the Pen in your hand as if you were writing. Depress the ON/OFF lever and open the supply reservoir to feed the Pen. As soon as all air has been purged from the supply hose and the pinch tube asembly, release the ON/OFF lever to shut off the fluid flow. 3. Attach appropriate dispense needle to the male luer lock fitting of the pen 4. To fine tune the flow control or dot size, use the included allen wrench to adjust the stroke of the ON/OFF lever. This adjustment is on the underside of the pen body, opposite from the lever. 5. The shot size can be adjusted by the following parameters: a. Pressure on the supply reservoir b. Dispense tip size c. Stroke adjustment on the ON/OFF lever 6. Normally the pinch tube assembly will provide 100,000 to 200,000 cycles before requiring replacement. When replacement is necessary, refer to detailed instructions in Section 3. �PINCH TUBE ASSEMBLY REPLACEMENT� |