Our precision dispensing systems handle most adhesives, liquids, gels and pastes without mess, waste, error or hand fatigue. These products have been assembled ready to use for specific fluid types and are supplied complete.

Adhesive Dispensing Ltd provide a wide range of equipment options for dispensing almost all assembly fluids - from watery liquids, solvents, primers and activators through to thick pastes, sealants, silicones, gels and epoxies.

Product Description

Cyanoacrylates are usually supplied in bottles ranging from 50g to 500g size. These bottles are placed inside a small pressure pot and fed under pressure to a small dispense valve which is timed by a controller unit. Other systems for CA's include syringe based digital low pressure dispensers and a peristaltic pump type system. All tubes, fittings and tips (wetted parts) are non clog plastics compatible with these reactive adhesives.

Silicones, RTVs and sealants are typically supplied in 310ml size caulking tubes. These can be easily applied using our range of manual and pneumatic 310ml cartridge guns where simple deposits are required. For timed shots of these materials, we place the silicone tube into a small pressurised retainer body and cap and feed it to a dispense valve which is controlled by a timed system. Our syringe dispensers are also ideal for making repeat shots and are simple to use..

Solder masks can be poured directly into our wide mouth pressure pots and fed to a small dispensing wand which is controlled by hand. Systems are available with a single pressure pot feeding up to 4 operators at a time. Easy to operate, keep clean and maintain - these systems provide a simple way to dispense solder mask fluids without mess or material waste. Systems come complete with fluid lines, manifolds, fittings and tips.

The most common method of applying solder pastes in small volume is direct from syringe barrels using a timed pneumatic dispenser. These allow the operator to set a shot size and at the press of a footswitch, apply fast and accurate deposits without mess or costly waste. For higher volume applications of dots or beads, the auger valve systems provide the ultimate in accuracy using a motorised screw for volumetric deposits to each part.

Solvents are often used for bonding plastics but have powerful fumes that can be harmful if tubs and pots are left open. We offer a range of products suited to the safe handling of solvents whether for plastic welding applications by hand or more automated processes. Solvents can be placed into small tanks and fed to a dispense valve or used with our syringe based low pressure dispensers. We also supply bottles and accessories for low volume solvent dispensing.

Conformal coatings, primers, activators, grease, lubricants and inks can be sprayed to products for bonding, coating and marking parts with total accuracy and control. Repeat deposits can be achieved and micro spraying of products down to very small areas with zero overspray. Systems are also used to coat tooling for metal stamping applications. Systems comprise of a micro spray valve, pressure pot and digital spray controller unit.

Cost effective quality systems for handling hot melt adhesives when used in packaging and product assembly applications. High specification melter units with event timers, multiple heated hoses, manifolds, nozzles and accessories to dispense hot melt adhesives whether by hand or as part of an automated assembly process. We also supply a range of hot melt adhesives and tank cleaners. The Thermadose range is fast becoming the alternative to more costly systems.

A range of off the shelf and custom assembled systems for the controlled application of two-component epoxy resins, PU's, doming adhesives and silicones. Allowing the materials to be mixed to the correct ratio then dispensed accurately without mess or costly waste. Using our range of products we can assemble systems to suit the material, application and demand. From plastic dual cartridges, static mixer nozzles to dosing valves and applicator guns.