|
|
|
|
Precision moulded 2.5 Inch long standard nozzle x 1/8 Inch (0.125 Inch) orifice. 1/4 Inch NPT thread to fit all cartridges and spool valves. Nozzle can be cut down if required.
If using with pre-filled sealant and silicone cartridge tubes that feature an external nozzle thread, use part number TSD931-296 adapter fitting. This will provide a leak free connection to the range of nozzles. Natural high density polyethylene (HDPE) material. Supplied in sealed packs of 10.
Nozzle 2.5 X 1/8 Inch (63.5mm x 3.2mm) orifice. The TS218-HO nozzle series is newly added to the portfolio presenting the continuous improvement to meet market and application demand. The HO- High Output - nozzle series has the same external dimensions and orifice diameter as the standard series nozzle, however, the internal fluid path is designed with minimal flow restriction to provide the highest fluid throughput possible. Also available in Low Density (LD) Polyethylene. - Optimum internal fluid path design - provides highest fluid throughput - Reduces operating time - generates higher yield - Lower air pressure requirement - reduces operating cost and enhances safety - Easy for manual tip cutting process - reduces operating time, cost and enhances safety - Requires less bending force - reduces operating time, cost and enhances safety - High Density (HD) Polyethylene
Part ID: TS218-500 Material: High Density Polyethylene (MDPE)
Colour: Natural
ID: 1/8 Inch (3.2mm)
Length: 2.5 Inch (63.5mm)
Connection: 1/4 Inch NPT Maximum Pressure: 100 PSI Details: Industrial Grade, Silicone Free Commodity Code: 84679200 Brand: TSI Pack Size: 500
Adhesive
Dispensing Ltd provide a wide range of equipment options for dispensing
almost all assembly fluids - from watery liquids, solvents, primers and
activators through to thick pastes, sealants, silicones, gels and
epoxies.
- Part ID: TS218-500
- Material: High Density Polyethylene (HDPE)
- Colour: Natural
- ID: 1/8" (3.2mm)
- Length: 2.5" (63.5mm)
- Connection: 1/4" NPT
- Details: Industrial grade, Silicone Free
Nozzles are designed to work with all industry standard industrial cartridges. Part TSD931-296 is required if using with pre-filled silicone and sealant tubes that feature and external thread nipple to cut. Nozzles are fully compatible with most fluids, adhesives, pastes and gels and useful for high viscosity pastes, sealants, silicones, mastics, solder pastes and compounds.
All nozzles are safe for use up to 100 psi pressure. Nozzles are not for medical use but are precision manufactured for industrial use. All nozzles are certified silicone-free to prevent contamination of any liquids dispensed from them.
Disclaimer: While reasonable
efforts have been made to ensure all information on this website is accurate,
Adhesive Dispensing Ltd. do not assume responsibility for any errors or
omissions. All specifications, illustrations, data and prices are subject to change
without notice.
|
|
|
|
|
|
|
|
|
|
|
|
|
Features
- Industry standard 1/4" NPT thread
- Silicone-free plastics
- Safe for use to 100 psi
- Can be cut to suit application
- Use on cartridges or valves
- Supplied in sealed packs
|
|
|
|
|
|
|
|
|