Pistons used with syringe barrels to ensure that the pressure is evenly spread across the fluid surface to provide consistent dispensing. Flat walled pistons prevent dripping and eliminate material waste by pushing out adhesives, gels and pastes under pressure from the syringe barrel. Maximum operating pressure is 100psi (6.9bar).
Straight Wall Pistons (red) are recommended for reduced stringing and bouncing with high viscosity products. The flat edges without wiper blades do not restrict the piston movement. Supplied in sealed packs of 1000 direct from stock. Syringe barrels are ordered separately,
Material: Polyethylene
Colour: Red
For Barrel Size: 5cc
Height: 10.00 mm
Outer Diameter: 12.70 mm
Codes: 7050006R-1000
Brand: TSI
Commodity Code: 39269097
Lead Time: Ex Stock
Adhesive Dispensing Ltd provide a wide range of equipment options for dispensing almost all assembly fluids - from watery liquids, solvents, primers and activators through to thick pastes, sealants, silicones, gels and epoxies.
   
- Material: Polyethylene
- Colour: Red
- For Barrel Size: 5cc
- Height: 10.00 mm
- Outer Diameter: 12.70 mm
Use this piston with the 5cc 700 series barrel 7050LL1NPK. It is ideal for general use with stringy and viscous pastes.
Pistons are made of plastic to wipe the adhesive, paste or liquid from inside the syringe barrel as they move down.
Once a syringe has liquid inside, insert the piston and push down on one side. This will allow air to escape and ensures the piston sits directly on the fluid without an air gap. When bottom filling using a barrel filler, the piston is pushed down and moves up as the liquid is fed into the syringe barrel.
|
