A07 is designed for the permanent sealing and locking of threaded fasteners. The product is a single component anaerobic, high strength, acrylic based thread locker. The product cures when confined in the absence of air between close fitting metal surfaces and prevents leakage and loosening from vibration and shock.

A07 is a heavy duty, permanent thread locking adhesive. High strength, high viscosity for coarse threaded fasteners over 1" (25mm) diameter. Recommended for use on hydraulic press studs, etc.

This adhesive can be applied using our syringe barrel dispensers or direct from the large bottles using our metering valves, controller and pressure pot. All adhesives are shipped with TDS and MSDS.

---

Technical Data Sheet (TDS)
Material Safety Data Sheet (MSDS)

---

Part ID: A07
Resin: Dimethacrylate
Bottle Size: 50 ml LDPE bottles
Colour: Red
Viscosity: 4,000 - 6,000 cps
Max Gap Fill: 0.25mm
Temp. Range: - 54 to 230 C
Fixture Speed: 15 - 30 minutes @ 25 C
Full Cure Time: 24 hours @ 20 C
Breakaway Strength: 20 Nm
Prevailing Strength: 30 Nm

---

• Part ID: A07
• Resin: Dimethacrylate
• Bottle Size: 50 ml LDPE bottles
• Colour: Red
• Viscosity: 5,000 cps
• Max Gap Fill: 0.25mm
• Temp. Range: -60 to 150�C
• Fixture Speed: 15-30 minutes @ 25�C
• Full Cure Time: 24 hours @ 20�C
• Breakaway Strength: 20Nm
• Prevailing Strength: 30Nm

Materials should not be used without consulting the MSDS, which contains full information regarding the use of this product, including Transport, Disposal, Toxicological, Exposure Controls, Accidental Release and First Aid measures essential to the safe use of this product.

Adhesives are shipped by tracked courier.