Liquid and adhesive dispenser designed to allow materials to be handled from up to 5 litre sizes. There is no pouring needed (ie: you can drop a bottle of glue right into the dip-tube tank). Very little clean up is involved with this system and you do not smell the strong fumes of the glue as this is a contained system.

The valve is designed to dispense thin and medium liquids with controlled deposits of glue, with no dripping. The system has two ways to control the deposit: - needle tip size and tank pressure. The pressure on the tank can be adjusted and there is a 0-75 psi regulator gauge.

Applying adhesives by hand can be slow and often too much is applied to each part which can create mess, waste and possible damage to products. Or too little adhesive can be applied which creates a weak bond and product failure. With this system, the adhesive bottle is placed directly inside the compact tank unit and fed under very low air pressure down flexible feed tubing to the hand held lever valve.

For CA's, dispensing tips supplied are Teflon lined to prevent rapid clogging of the adhesive. Using Teflon tips allows the operator to dispense without it blocking too quickly in between breaks or them having to replace tips too often. For other liquids, a range of Smooth Flow Tapered, Precision TE Tips and Polypro Flexible Tips are also provided.

This dispensing system will ship with a starter stock of dispensing tips, tip caps and fluid lines. The only requirement for this system is a compressed air supply of 60-75 psi. We recommend that the air supply is filtered against moisture if using reactive adhesives such as Cyanoacrylates. We supply low cost 5-micron filters (part TSD800-6).

This version is for 1 or 2 operators. It includes 2 x TS1201 hand lever valves, a liquid manifold system connected to the 5 litre pressure pot. Either 1 or both operators can use the system at the same time.